VXP Racing Portable ESC Programming Card Program Box Car Boat 90-400A 6-22S

Description

VXP RACING - Portable Programming Card Program Box for High Power High Voltage ESC
for CAR & BOAT ESC
90 - 400A 2-22S Lipo
No more irritating BEEP BEEP BEEP to program your ESC and to check the Settings.
Just plug in and read the Settings and to change the Settings. ( Always plug in Program Box before Power ON ESC or it will revert to Factory Settings )
Only suitable for VXP Racing ESC.
Programming Instructions
- plug Prog Box to ESC ( align the color wires correctly to the Prog Box )
- then plug ESC to Motor, turn ON Radio
- plug battery to ESC, power ON (use the Anti Spark Cable, Prog Box will light up, there should not have any melody and beep from the Motor, if have - power OFF then power ON again and again till Motor is quiet)
- do your settings
- to send settings to ESC ( press and hold the two center buttons - count to from 1 to 5 )
- Prog Box screen will says "Data sending to ESC"  then a while BLINK
- power OFF then power ON ( use Anti Spark Cable as sparking can render the programming to default setting, there
should not have any melody and beep from the Motor, if have - power OFF then ON again and again till Motor is quiet)
- check your new settings in Prog Box
- If yes - power OFF then remove Prog box.
- Done
If setting does not stick - repeat procedure again.
To run Motor after Programming
- power ON - not touching the Throttle ( melody then a few Beeps then silence )
- Press Throttle - Motor will run.
Revert to Factory Settings
- power On ESC, power ON Radio ( melody then a few beeps then silence )
- plug Prog Box to ESC ( match color wire to the side of Prog Box )
- Read settings this will be Factory Settings
- make changes if you want
- to send settings to ESC ( press and hold the two center buttons - count from 1 to 5 )
- Prog Box screen will says "Data sending to ESC"  then a while BLINK
- power OFF then power ON ( use Anti Spark Cable as sparking can render programming to default settings,
there
should not have any melody and beep from the Motor, if have - power OFF then ON - again and again till Motor is quiet
)
- check your new settings in Prog Box
- If yes - power OFF then remove prog box.
- Done
If setting does not stick - repeat procedure again.
Anti Spark Cable
- Solder a crocodile clip at the end of the Anti Spark Cable . And clip the crocodile clip to the (purposely) exposed part of shrink wrap of the BLACK Cable of the battery. Then connect the main connectors to battery.